Settings On The C24 Module In The Melsec Plc System - Beijer Electronics E-Serie Installationsanleitung

Settings on the C24 module in the MELSEC PLC
system
AJ71(U)C24
Station number:
When communicating with the E-series: 0
Mode setting:
When communicating with the E-series: A
Setting of the switches:
Default
comm.
Switch settings in
E-series
software
SW11 ON
SW12 ON
SW13 OFF
SW14 ON
SW15 ON
SW16 OFF
SW17 OFF
SW18 OFF
SW21 ON
SW22 ON
Position of setting
Setting items
ON
Main channel RS-422
settings
Data length 8 bits
Transmission Refer to the table below
speed setting
Parity check Enabled
Parity setting Even
Stop bit 2 bits
Sum check Enabled
Write during Enabled
RUN
switch
Notes
OFF
RS-232C Valid for
modes A to D
7 bits –
–
Disabled –
Odd Valid only
when SW16
is ON
1 bit –
Disabled For dedi-
cated protocol
Disabled
C-1