Installation To Wood Stud Wall - Paramount PA740 Montageanleitung

Installation to Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations (not UL approved).
Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to
2
edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm)
deep. Attach wall mount (A) to wall using two #14 x 2.5" flat head wood screws (H) as shown.
Skip to step 3 on page 7.
A
WARNING
WALL
PLATE
H
5 of 46
ISSUED: 01-27-08 SHEET #: 095-9283-3 06-12-09
WOOD
STUD