Blaupunkt VCB301 Bedienungsanleitung Seite 7

VCB301
1. Nozzles:
1a) Multi-purpose brush nozzle Crevice tool
1b) 2-in-1 crevice tool Multi-purpose brush nozzle
1c ) Dust brush
2. Telescopic tube
3. Hose handle
3a) Suction control on the hose handle
4. Hose
5. Full bag or airflow blockage
indicator
6. Button:
PREPARATION OF THE VACUUM CLEANER FOR WORK
Make sure that the bag has been correctly placed into the vacuum cleaner compartment and it is not
full. Insert the hose connector into the vacuum cleaner inlet and lock it. Connect the hose handle with
the telescopic tube or nozzle. Put an appropriate nozzle on the telescopic tube. By grabbing the plug,
unwind the power cord. Pay attention to the yellow band on the cord which signals the end of the cord.
Connect the plug to a power socket. Turn on the vacuum cleaner with the switch button (6b).
WHEN THE VACUUM CLEANING IS DONE
Unplug the power cord from the wall socket. It is recommended that the cord be rewound by pressing
the cord reel button (6a). Make sure that the cable is loose, it is not blocked by anything and gently
hold the cord to prevent it from tangling and to avoid the strong impact of the plug on the housing.
Disconnect the nozzle, tube and hose. Clean these parts.
The vacuum cleaner may be stored in a vertical or horizontal position.
Be careful not to bend the hose excessively, this may result in its deformation or damage.
CLEANING AND MAINTENANCE
Regularly clean the nozzle, tube, and hose from hair and other impurities.
Wipe the body with a slightly damp cloth, then wipe until it is dry.
Replacement of the bag is recommended when it seems to be full or when you feel a drop in suction
power or when it is signalled by the full bag indicator (5).
If you used a disposable bag, remove and discard it.
Replace the inlet air filter once per three bag replacements. Included in the Blaupunkt ACC042 set.
Failure to replace the inlet air filter can lead to a decrease in the suction power, and in extreme cases in
dust getting into the motor and damage to the appliance.
Place the dust bag on the holder following the indications.
It is recommended that the air outlet filter be replaced every 6-12 months depending on the intensity
of use of the vacuum cleaner.
6a) cord reel
6b) power switch
7. Air outlet grille
8. Hose connector
9. Bag compartment cover catch
10. Holder
11. Motor inlet filter
12. Removable microfibre bag Reusable
cloth bag
5