Sanus MF209 Bedienungsanleitung Seite 9

2
Wall Mounting - Solid Concrete
and Concrete Block
2-1
Level wall plate [02] and mark hole locations
2-2
Drill pilot holes as illustrated
2-3
Insert anchors [25]
2-4
Tighten lag bolts [23] only until the washers [24] are pulled firmly against the wall plate [02]
[24]
[23]
CAUTION:

Mount the wall plate [02] directly onto the concrete surface.

Minimum solid concrete thickness: 203 mm (8 in.)

Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.)
NOTE:
NOTE:
[02]
TV will shift 15 cm (6 in.) to the right or left when in the home position.
Consider this when selecting the location of your wall mount.
For assitance in determining wall plate location, see Height Finder at sanus.com.
CAUTION:


CAUTION:
the anchors [25] seat flush with the concrete surface.
CAUTION:
bolt. To avoid potential injuries or property damage DO NOT over-tighten
the lag bolts [23].
Fit lag bolt covers [26] over lag bolts [23].
NOTE:
[02]
[24]
Avoid potential personal injuries and property damage!
The MF209 is shown.
For the MF209 only:
To avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a 10 mm
(3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
75 mm
(3 in.)
To avoid potential injuries or property damage be sure
[25]
Improper use could reduce the holding power of the lag
The MF209 is shown.
[23]
[26]
13 mm 10mm
(1/2 in.) (3/8 in.)
9