Werbung
GB
Parts Replacement
Attaching the adjustable armrests
Remove the armless caps using a flathead screwdriver, etc.
1
2
Fix the arms from the side using the supplied bolts (one
bolt per side).(Tool required: 6 mm hexagonal wrench)
Make sure the attached parts do not rattle.
3
Attaching the headrest
Remove the name plate on the rear top of the backrest
1
frame using a flathead screwdriver, etc.
2
Insert the headrest from above into the top of the backrest
frame while aligning it with the three holes. Make sure it is
fully inserted.
3
Fit the supplied screw plate into the holes at the rear top of
the backrest frame, then secure the headrest with the two
screws provided. Attach the name plate on the headrest.
4
Make sure the parts do not rattle.
Attaching the lumbar unit
1
From the back of the chair, fit the lumbar unit between the
left and right frames while bending it inwards.
Insert the four clips of the lumbar unit into the grooves on
2
the inside of the backrest frame. Use the installation guide
lines to determine the installation position.
21
1
2
Armless cap
Headrest
2
Screw plate
3
Rear top of
the backrest frame
1
Name plate
Installation
guide lines
Attaching the garment hanger
For low-back and high-back chairs
1
Remove the name plate on the top of the backrest frame
using a flathead screwdriver, etc.
Adjust the height of installation (4 levels) using the grooves
2
on the left and right of the hanger unit. As a guide, install at
the lowest level for a low-back chair and the highest level
for a high-back chair. Take extra care when setting the
height of installation so as not to get your jacket caught
between the floor and the casters when the seat is reclined.
3
Position the hanger unit between the hanger attachment
plate and the screw plate, and secure the hanger using the
two screws provided. Attach the name plate on the hanger
attachment plate.
4
Make sure the parts do not rattle.
For extra-high back chairs
Remove the name plate from the headrest using a flathead
1
screwdriver, etc. Remove the two screws used to secure
the headrest.
Adjust the height of installation (4 levels) using the grooves
2
on the left and right of the hanger unit. As a guide, install at
the lowest level for a low-back chair and the highest level
for a high-back chair. Take extra care when setting the
height of installation so as not to get your jacket caught
between the floor and the casters when the seat is reclined.
Position the hanger unit between the hanger attachment
3
plate and the screw plate, and secure the hanger using the
two screws which were removed in step 1. Attach the
name plate on the hanger attachment plate.
4
Make sure the parts do not rattle.
* Do not use the screw plate and screws provided for extra
high back type.
Rear top of
Hanger unit
the backrest frame
Screw plate
2
1
3
Name
plate
Hanger
attachment plate
Headrest
Hanger unit
2
1
3
Name
plate
Hanger
attachment plate
22
Werbung
