Inhaltsverzeichnis
Werbung
notes for setup:
•
Setup sequence only starts in case of correct RC reception.
•
Setup can be repeated at any time by power-cycling (with jumper).
•
If the device is switched off before the end of the setup sequence, no change will be saved but a possible, previous setup retained. If the jumper is pulled out before the
end of the setup, the system's condition is undefined. Repeat setup.
•
Do not teach any extremely short throws as full deflection. This can lead to errors, as the system does not recognise any greatly reduced throw clearly as deflection.
•
The jumper may not under any circumstances touch the central pin in its slot electrically. It may only bridge the outer pins.
06 switching on flight operation
Start the CORTEX in normal operation without the connected jumper. The LED flashes red for the first 6 seconds and indicates that the system and the gyros are being
initialised. The model must not be moved during initialisation. Otherwise, the stabilisation remains inactive (flashes red, see Section 7) until switch on is repeated.
When the system and gyros have been initialised, the servos will indicate this by jerking twice. The LED lights up constantly; its colour indicates the setting (mode)
of the gyro channel.
Each time it is switched on, the CORTEX also recognises the transmitter's trims. This is why no control movements must be given until initialisation is complete directly
after the device is switched on.
07 led
• • • • • (5x)
Switch on
Flashes red 5x → Do not move the model and control sticks, gyros initialising
Fault
• • •
(3x)
Flashes (cycle of 3) → Gyro deactivated, initialisation failed
• • •
Flashes yellow-orange → is waiting for RC reception
Setup
• • •
Flashes or flickers green → Setup mode (teach-in process with jumper)
Operation
Permanently illuminated → Depends on the gyro channel (see Chapter 8)
7
Werbung
Inhaltsverzeichnis
