Connecting Servos; Securing The Cortex - Bavarian Demon CORTEX Kurzanleitung

03 connecting servos

The servos to be stabilised are connected to CORTEX's outputs A to E. The same assignment applies as for the input side, i.e. as used for the receiver
connection. Cable A on the receiver corresponds to slot A on the CORTEX etc
AUX
Channels that are not subject of being stabilised, e.g. gas, must not be looped through, but must remain connected directly to the receiver.
Only for serial receiver connection (sum signal):
If the receiver also has individual outputs/servo connections alongside its serial output, any not stabilised channels (throttle, landing flaps etc.) will remain
connected to the receiver. If the receiver only has the serial (sum) connection, even these functions must be passed through the CORTEX. The special outputs
F (gas) and G (output 2) are available for this. Connection F may be used for other functions, e.g. with gliders without motor. Port G (output 2) only supplies the
signal and no voltage. Earth (black cable) and battery plus (red cable) must be connected from another slot, in case using a Y-cable.
Control test without gyros:
Now all the servos must run correctly and identically as before (without gyro assistance). Otherwise, check the assignment of the connections, or the channel
assignment per PC software for serial receiver connection.
( ! ) Even if the servos are running correctly: do not fly before setup of the CORTEX and gyration directional test is complete. Incorrect gyro effect would
certainly result in a crash!

04 securing the corteX

It is crucial that the installation position shown here is followed.
Exception: further installation positions can be programmed using PC software.
The adhesive foam pads supplied must be used. Use the thin pad ‚acro' for electric, nitro and turbine powered models and for vertical installation.
The thick and softer pad (‚soft') is recommended primarily for models with a combustion engine.
Any dirt must be removed before applying the pad so that the device does not become detached. The model would become uncontrollable.
Also do not tie the housing tightly so as not to restrict the dampening effect of the foam pad. For the same reason, do not lay the connection cable
(servos and receiver) in a taut but in a loose loop.
A
B
C
A
D
B
E
C
D
E
5