Initial Operation; Working Advice - Berner BACWL Originalbetriebsanleitung

OBJ_BUCH-3354-001.book Page 18 Wednesday, August 30, 2017 10:30 AM
 Do not continue to press the On/Off switch after the cordless
worklight has been automatically switched off. The battery can be
damaged.
To remove the battery 2, press the unlocking button 3 and pull the bat-
tery out of the cordless worklight. Do not exert any force.
Observe the notes for disposal.
Operation

Initial Operation

Inserting the battery
Insert the charged battery 2 into the lamp head 1 until you feel it en-
gage.
Switching On and Off
To start the cordless worklight, press the On/Off switch 9.
To switch off the cordless worklight, press the On/Off switch 9 again.
To save energy, only switch the cordless worklight on when using it.
Adjusting the Brightness
Press the On/Off switch 9 briefly to switch on the cordless worklight at
maximum brightness. To adjust the brightness in 2 stages, hold down
the On/Off switch 9 until the required brightness is obtained.
Temperature Dependent Overload Protection
When exceeding the allowable heat-sink temperature of 50 °C, the
cordless worklight switches off. Allow the cordless worklight to cool
down, then switch the cordless worklight on again.

Working Advice

The cordless worklight runs at reduced brightness when the battery ca-
pacity is at approx. 1.3 %. The cordless worklight flashes 3 times be-
fore the brightness decreases.
Swivelling the Lamp Head (see figure A)
The lamp head 1 can be swivelled up to 200 ° to suit the application.
18 | English
1 609 92A 44S • 30.8.17