Maintenance - Qlima ASE 1020 Bedienungsanleitung

3. USAGE:
Vacuum cool ash and dry residue only
• Always make sure the filter is installed!
• When the container is full or it feels difficult to vacuum more dust, the
filter needs to be taken out and cleaned.
• While vacuum the fireplace ash, the ash temperature must be below
40°C. Do not vacuum hot ashes for longer than 10 seconds if the fire is
not extinguished! (Fig. 5).
G
TIP:
When suction power is reduced: carefully tap on the lid or carefully tap
container to the floor to possibly remove the blockade.
4. AFTER USAGE:
• Press the switch 13 to turn off vacuum cleaner.
• Pull out plug.
• Roll up the power cable.
• Disassemble the hose 7 from the appliance.
• Take the lid 3 from the appliance.
• Empty the container body 1 and wash it.
• Use rag to dry container body 1.
• Take out the filter B / C / G and (if applicable) the metal mesh cover D,
and clean and wash it carefully (picture 6), and dry it in air before in-
stalled on vacuum cleaner. Filter and metal mesh cover can be removed
using the 'turn anti clock wise and pull method'. For the metal mesh
cover is might be necessary to loosen the metal screws just a little bit.
• Reinstall B / C / G and D (if applicable) following the 'push and turn
clock wise method'. Make sure that the metal mesh filter is fixated by
fixating the relative screws.
• Replace the lid 3 and fixate the locks 2

5. MAINTENANCE

The container body 1 and outer shell of lid 3 need to be cleaned fre-
quently.
• Never use a detergent and/or cleaning agent as this might result in
damages
• The dirty container should wash with the clear water only.
ASZ TYPE ONLY:
Make sure that water never comes in contact with the lid, as this can
cause significant damage and or risk with respect to the electrical parts!
• Wash the filter with the clear water only.
• If the appliance working unsatisfactory, it is usually resulted from the
jam of hose 7 or conjunction of pipes, filters or accessories. In that case,
please clean the parts concerned.
52