Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GOLIATH SENIOR
SPECIFICATIONS
Description: 6x10 + Tweeter Speaker Enclosure
Power Handling: 1000 watts RMS
Impedance: 4 Ohms
Frequency Response & SPL: 110 dB SPL @ 1W1M
(–3 dB @ 55 Hz and 14 Khz)
Speaker Complement: (6) 10" P.A.S Drivers, (1) Foster Horn
Heavy-Duty Casters, Spring Loaded Rubber Grip Handles, Bottom Slot
Port, Top Handle and Tilt Back Design for easy transportation.
Dimensions: 23.25"W x 36.5"H x 18.5"D
Weight: 115 lbs.
P.A.S 10" SPEAKER SPECIFICATIONS
Free Air Resonance: 47Hz
Individual Impedance: 8 Ohms (each)
Power Rating: 175 Watts RMS (each)
CONNECTION AND OPERATION
Goliath Senior can be connected to any musical instrument amplifier capa-
ble of driving a 4 ohm load. To connect your amplifier to Goliath Senior, run a high quality speaker cable (18 gauge or heavier)
from your amplifier's speaker output to one of the designated speaker inputs (Speakon or 1/4") on Goliath Senior's input
panel.
POWER HANDLING
The power output rating for any amplifier connected to Goliath Senior should not exceed the enclosure's 1000 watt RMS
power handling capacity. Please be aware that exceeding Goliath Senior's power handling capacity can void the SWR warranty
if any damage occurs to your loudspeakers due to overpowering.
FULL RANGE INPUT AND OUTPUT JACKS
Goliath Senior features four, full range input/output jacks (two standard 1/4" and two Speakon) wired in parallel. If you are run-
ning two speaker enclosures in parallel, connect the speaker cable from your amplifier to either jack labeled "IN, " and a sec-
ond speaker cable from either jack labeled "OUT" to the input of the second speaker enclosure.
TWEETER ATTENUATOR CONTROL
The large dial found on the input panel of the cabinet is the Tweeter Attenuator. This control is used to adjust the level of high
frequency signal present at the tweeter. A normal setting for this control is straight up or "twelve o'clock." Turning the dial fully
counter-clockwise removes the tweeter from the circuit. As you turn the dial clockwise from this position, the high frequency
content is increased.
INTERNAL CROSSOVER
Goliath Senior's internal (passive) crossover divides the incoming signal into two frequency bands. The crossover point is 5
kHz (frequencies above 5 kHz are sent to the tweeter, frequencies below 5 kHz are sent to the 10" speakers).
Professional and Custom Pro Specialist Series • 15
Werbung
