Avacom PWRB-6000 Bedienungsanleitung Seite 3

POWER BANK PWRB-6000
Thank you for buying the power bank PWRB-6000. Please read the following
information before you start to use it.
PACKAGE CONTENTS
Power bank
ź
Operation manual
ź
GENERAL INFORMATION
The power bank contains high quality power cells Sony. The power bank
ź
is suitable for charging the most mobile phones, tablets, MP3/MP4 players,
digital cameras and other mobile devices that have the supply voltage equal to
the output voltage of the power bank and can be recharged by using micro USB
or lightning connectors .
The power bank has an integrated motion sensor that turns on the power bank
ź
when shaking it
The power bank has a built-in cable with the micro USB connector, the USB
ź
connector and also a reduction with the lightning connector which allows
connect the power bank to Apple devices.
An intelligent chip which is a part of the power bank automatically sets the most
ź
suitable mode and a built-in fuse protects your devices against effects
of excessive current or short circuit.
The power bank can detect connected devices and automatically start
ź
charging. After pulling off the built-in cable, the power bank is automatically shut
down after a while.
Power bank LED indicators provide an overview about the current charge
ź
status of the power bank.
CHARGING INSTRUCTIONS
Shake gently the power bank to find out the current status of charge. If all the LED
indicators lit up the power bank is fully charged. Connect the power bank to your
mobile device by using the cable with the micro USB connector or by using the
lightning reduction (picture 1). The power bank starts charging your device
automatically after a while. After pulling off the cable from your mobile device the
LED indicators go off and the power bank is automatically shut down after a while.
Picture 1
LED indicators
Micro USB conector
Mobile devices
Lightning
reduction
Picture 2
USB conector
The power bank can be charged by using the cable with the USB connector that
can be connected to a charging adapter equipped with an USB port or to an USB
port of your notebook (picture 2). During charging the power bank its LED
indicators will gradually turn on depending on the status of charge. The power bank
is fully charged when all of its LED indicators lit up continuously.
SAFETY INSTRUCTIONS
Please read the instruction manual that contains important information about
ź
using the power bank.
The warranty cannot be applied if the power bank gets damaged due to non-
ź
compliance with these instructions.
Use the power bank only in accordance with its technical specifications.
ź
A seller is not liable for any consequential damages to property or personal
ź
injury caused by improper use or non-compliance with the safety instructions.
For safety reasons the power bank cannot be modified nor its technical
ź
specification changed in any way.
Do not allow children to play with the power bank and keep it out of their reach.
ź
If you notice that the power bank is damaged, stop using it immediately.
ź
Do not expose the power bank to temperatures lower than -10°C or higher
ź
than 50°C.
Keep the power bank always in a dry environment.
ź
RECYCLING
After the end of the power bank's service life, the power bank must be handed over
to a collection point for recycling of electrical and electronic parts. Recycling
symbols are written on the product and its packaging.
TECHNICAL SPECIFICATIONS
Capacity: 6000mAh
Intput: DC 5V/max. 2A
Output: DC 5V/max. 2.1A
Type of battery cells: Li-Ion 3.7V
Made in China for AVACOM s.r.o.