Setting The Time; Setting The Date; Using The Chronograph - Sector RETROGRADE 0S22 Bedienungsanleitung

0S22 inglese
1

SETTING THE TIME

1. Pull the crown out to the 2nd position so that the second hand stops at
ZERO position.
2. Turn the crown to set hour and minute hands.
3. When the crown is pushed back to the normal position in synchronization
with a time signal, small second hand begins to run.
2

SETTING THE DATE

1. Pull the crown out to the 1st Click Position.
2. Turn the crown counter-clockwise to set the date.
* If the date is set between the hours of around 9:00 PM and 1:00 AM,
the date may not change on the following day.
3. After the date has been set, push the crown back to the normal position.
3

USING THE CHRONOGRAPH

This chronograph is able to measure and display time in 1/20(1/1) second
united up to maximum of 59 min 59 sec. The retrograde chronograph
21-12-2007 15:59 Pagina 3