Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Confirm the information that appears on the Settings Overview screen is correct,
then click "Save" to save the settings and reboot the router. NOTE: Click "Back" to
change settings on a previous screen.
4. After saving and rebooting the router, the ISP settings are done. The wizard will
then help to set your computer to obtain an IP address from the router automatically.
A screen with a status bar will display to indicate the progress of the procedure.
NOTE 1: To use the router to access the Internet, the IP address of each PC needs to
be set in the same network segment as the router. The wizard will help to set the
proper IP address for your computer.
NOTE 2: By default, the router's DHCP server is enabled. If it's disabled before
running the wizard, the wizard will enable the DHCP server automatically.
5. The wizard will attempt to connect to the selected ISP. If the attempt fails, a screen
prompt will indicate this is the case. Run the wizard to select the ISP again.
6. If you do successfully connect to the ISP, you'll see a confirmation screen. To
configure additional Web management settings, click "Advanced Settings. " To close
the wizard, click "Finish. "
Setting the ISP Manually
If the wizard is unable to find the ISP, follow the steps below to configure the ISP settings
manually. First, however, check with your ISP as to what kind of service is provided,
such as PPPoE, PPPoA or RFC1483/2684. Obtain the corresponding information as
shown here and keep it for reference.
PPPoE
PPPoA
RFC1483 Bridged VPI/VCI, VC-based/LLC-based multiplexing to use Bridged Mode
RFC1483 Routed VPI/VCI, VC-based/LLC-based multiplexing, IP Address, Subnet
1. Without the correct ISP listed, select "Other. "
4
ENGLISH
VPI/VCI, VC-based/LLC-based multiplexing, Username, Password
(and Service Name)
VPI/VCI, VC-based/LLC-based multiplexing, Username, Password
Mask, Gateway Address, and Domain Name System (DNS) IP
Address (a fixed IP address)
Werbung
