Try To Connect To A Website; Configure The Router - Cisco Systems SB 106 Verkabelung Und Einrichtung

Try to Connect to a Website

This product relies on the building's installation for short-circuit (overcurrent)
Warning
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S.
(240 VAC, 16A international) is used on the phase conductors (all
current-carrying conductors).
This equipment is intended to be grounded. Ensure that the host is connected to
Warning
earth ground during normal use.
Try to Connect to a Website
Log in to a PC that is connected to the router, open a web browser, and connect to
a website. If you successfully access a website, you do not need to change the
configuration and you have completed setup. If you cannot access a website,
follow the steps in the

Configure the Router

Configure the router by following the instructions in the Cisco Router and
Security Device Manager (SDM) Quick Start Guide. This document shows you
how to connect your PC to your router and how to use SDM, a configuration tool
that you run from your web browser.
Additional information about SDM is available at the following URL:
www.cisco.com/go/sdm
Click the Technical Documentation link to view release notes and other SDM
documentation.
Cisco SB 106 Router Cabling and Setup
1-8
Chapter 1
"Configure the Router" section on page
Cisco SB 106 Router Cabling and Setup
1-8.
78-16773-01