Whispbar K508W Fitting Kit Montageanleitung Seite 7
Basisträgersystem
Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
EN
Fitting Kit
K508W
Tighten adjusting screw to 3 Nm (2.2 ft lb)
hand tight.
Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
Remove both pins from each leg. Use
tapered end of spanner located inside left
hand cover to assist.
7
Inhaltsverzeichnis
