Troubleshooting; Cleaning - Silvercrest SND 3600 B1 Bedienungsanleitung Und Serviceinformationen

Troubleshooting

The power LED (2) does not light up.

Check whether the digitizer is connected correctly to your computer. If
possible, connect the digitizer to a different USB port.
Stains are visible on the scanned images.

The negatives/slides are dirty. Clean the negatives/slides. Proceed
carefully here in order to avoid damaging the negatives or slides.

The backlight of the digitizer is dirty. Clean it with the supplied cleaning
brush. For further details, please read the next section "Cleaning".
Scanned images are blurred

The lens of the scanner may have fogged up due to temperature
differences. Wait until the device has acclimatised and then try again.

Cleaning

Use a slightly damp cloth to clean the digitizer and its accessories and never
use any solvent or cleaner that would corrode the plastic materials. Ensure that
no liquid can penetrate the housing of the digitizer.
Use the cleaning brush to clean the backlight of the digitizer. Slide the cleaning
brush with the cleaning surface facing downwards into the negative/slide slot
(3).
SilverCrest SND 3600 B1
English - 19