Storage; Ats3080 And Power Pack 3080; Strap And Closures; Installation - HellermannTyton 3080 Montageanleitung

4 .4 Storage

4 .4 .1 ATS3080 and Power pack 3080

f ATS3080 and Power pack 3080 in a cool, dry place.
f Avoid direct sunlight.
f ATS3080 and store Power pack 3080 in dustproof
packaging.
f Store electrical components (ATS3080 and Power
pack 3080) in impact-absorbing packaging and
separately from the accessories.
f Consult and comply with the appropriate data sheets for
storage of the accessories.

4 .4 .2 Strap and closures

NOTE
Strap and closures are not resistant to ageing. The plastic
deteriorates if storage time is prolonged.
f Use up the strap and closures promptly.
Storage temperature
Relative humidity
f Always store the strap reels and the closure reels until
needed in the bags in which they are supplied and make
sure that the bags remain airtight. If necessary, seal the
bags with adhesive tape.
f Do note keep in storage for longer than 6 months.
f Never leave the packaging open for longer than
12 hours.
f Do not open the packaging until immediately before the
contents are to be used and use up the whole strap
promptly.
f Do not expose the strap reels or the closure reels to
direct sunlight.
f Keep the strap reels and the closure reels away from
sources of heat.
Assembly instructions Montagevorrichtung horizontal 3080 • 03-2017 • v02 • 102-01011

5 Installation

5 .1 Installing Bench mount kit horizontal 3080

Tools needed
• Open-ended spanner, w/f 10 mm
• Allen key, w/f 5 mm
Crush hazard when jaws close
f Always keep the Power pack 3080 pack switched off
f Depressurise the compressed-air system and secure it
5 .1 .1 Setting up Bench mount kit horizontal 3080
20 °C – 23 °C
50% rel.
4
f Position the base
f Secure the Bench mount kit horizontal 3080
f Connect a grounding cable (min. 16 mm
CAUTION
while installation is in progress.
against unintentional restart.
of Bench mount kit
2

horizontal 3080

on a clean, level and flat worktop.
1
worktop with three mounting angle brackets
cannot slip out of position.
Recommended screw size: M6 x 25 mm (min.)
the Bench mount kit horizontal 3080
Installation
1
2
3
to the
1
so that it
3
2 ) to stud of
4
.
1
8