Bestway 68045 Benutzerhandbuch Seite 2

INTRODUCTION
Proper Use
Any use other than that described or any modification of
the product is not permissible and may result in injury
and/or damage to the product. The manufacturer is not
liable for damage caused by improper use. The product is
not intended for commercial use.
Description of parts and features
A
Tent Peg
1PC 2PCS
Bestway
D
Manual
1PC
Tent Dimensions:
Tent: 192cm x 120cm x 85cm
Pitching dimension: 200cm x 130cm
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent
fabric. We recommend that you always position your tent
upwind from a camp fire. This will reduce the chances of
having embers land on your tent. In case of fire, please
find the exit to escape from the fire.
Never set up the tent near the river, under the tree of
other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to
avoid suffocation.
SAVE THESE INSTRUCTIONS
ASSEMBLY
Setting up the tent
FIG1
1. Take the tent<A> out of the carry bag <C>, remove the
strap and release the tent <A> away from you.
WARNING: The tent <A> is under pressure and should
be handled with precaution. Release the tent<A> away
from you.
2. Hammer the pegs<B> into the ground through the rings
of the tent <A> corners. (FIG1)
Owner's Manual
Model No.#68045
SECURA BEACH TENT
B C
Carry Bag
1PC
Repacking
A
D
A
C
B
D
B
NOTE: Drawing for illustration purpose only. May not
reflect actual product. Not to scale.
1. Remove the pegs <B>.
2. Gather top edge and base edge together at
center. (FIG2)
3. Left the tent up, with one hand grasp the top, side and
base edges at the cent, with the other hand push the
edge with point A downward to point B and inward to
point C. (FIG3)
4. Push edges with point D and E down and inward
until it forms ring shapes on ground. (FIG4)
5. Slide rings over the top of each other and adjust rings
to lie on top of one another. (FIG5)
6. When all rings are aligned, slide strap over rings to
hold them together. (FIG6)
DISASSEMBLE AND MAINTENANCE
1. Clean the tent and remove any stains with sponge and
cool water. Please use non-detergent soap for serious
cleaning.
2. Never machine wash or machine dry the tent. Hand
wash and air dry.
3. Please allow all parts to dry thoroughly before you
repack the tent. This will prevent the formation from
mould, bad odours and discolouration
4. Stitch with thread to repair minor leaks, fabrics and
plastic sheets damage. Use ropes to connect broken
frame parts. Use tapes to repair the coating broken
parts.
5. Silicone spray could be used onto zippers if stick.
STORAGE
Store the tent in the stuff sack and place it in a cool, dry
area out of sunlight and away from heat sources and
rodents.
2
D E
A
E
D
E
A(C)
B
E
B
FIG5
FIG2
FIG3
FIG4
FIG6
S-S-002068