Assembly; Mounting The Main Unit - LIVARNOLUX Z31999 Montage-, Bedienungs- Und Sicherheitshinweise

Replace the rechargeable batteries if the light output does not improve
after charging (Fig. E).

Assembly

Note: Before mounting, decide where you want to mount the solar cell
and the main unit
solar cell and the main unit is approx. 2.5 m long.

Mounting the main unit

Please remember when selecting the location for mounting the main unit
1. The connection between the LED spotlight
ble and should be able to illuminate the selected area. Please remem-
ber to slightly loosen the swivel screw before moving the LED spotlight.
Tighten the swivel screw afterwards (see Fig. F).
2. Depending on the mounting height (ideally between 1.80 m – 2.00 m)
the motion detector
tection angle of 90° horizontally and 90° vertically.
3. Be sure the motion detector is not illuminated by street lighting at night.
This can influence its functioning.
Secure the main unit
(ø 6 mm) and two of the enclosed screws
Note: The enclosed mounting material is suitable for ordinary masonry
construction. Other wall substrates may require other fastening materi-
als. Seek specialist advice when in doubt.
After mounting, check that the main unit is fitted securely.
. Please remember the connection cable between the
1
has a detection range of max. 12 m with a de-
3
using two of the enclosed wall plugs
1
and the main unit is flexi-
2
(4 x 30 mm) (see Fig. B).
7
5
:
1
8
GB 11