Troubleshooting - Clarity EXL30 Bedienungsanleitung

UK
CONNECTING A SPEECH PROCESSOR
COCHLEAR IMPLANT ADAPTER CORD
Caution: Before plugging any cord into your speech processor, you must consult your implant
manufacturer.
• Plug the mono end of the plug into the speech processor.
• Plug the stereo end of the plug into the Audio Output
socket on the telephone.
• Speak into the handset when using the Cochlear Implant
Adapter Cord.
OUTGOING VOICE AMPLIFICATION
The EXL30 can amplify your outgoing voice by up to 15dB.To use this feature, set the Outgoing
Voice Amplifier switch to AMPLIFY located underneath the telephone unit.
NOTE: The factory pre-setting is NORMAL.
TROUBLE SHOOTING
PROBLEM
No dial tone.
Check all the telephone cable connections.
PROBLEM
Call cannot be dialled, or dials very slowly.
Reset the Dial Mode Switch (see Setting the Dial Mode).
PROBLEM
Visual Ring Indicator is not very bright.
Check and replace the 9 Volt battery.
PROBLEM
No number is dialled when the memory button is pressed.
No number stored in that Memory Button (see Programming the Memory Buttons.
PROBLEM
Call comes in but the telephone does not ring.
Check that the Telephone Line Cable is correctly connected.
11
M 1 M 7
M 2 M 8
M 3 M 9
M 4 M
10
M 5 M 11
M 6
®
1 2 A 3 D
B E
C F
4 G 5 J 6 M
H K N
I L O
Q
7 R 8 T 9 X
S P U Y
V W Z
* 0 #
HOLD PROG FLASH REDIAL
AMPLIFY
TONE VOL
LO HI
WARRANTY
• The following 2 year warranty and service information applies only to product purchased and
used in the countries listed on page 1.You may also contact your local retail dealer for warranty
information in your country.
• Clarity guarantees the satisfactory condition of the equipment with regard to manufacturing
and material defects for 2 years from the date of purchase. (Please keep your original
receipt safely).
• This product must be installed and used in accordance with the instructions contained in this
User Guide, and serviced at an approved Plantronics Service Centre. Failure to comply with
these conditions may render the warranty invalid.
2 YEAR WARRANTY AND REPAIR SERVICE
• Products under warranty are replaced free of charge.
• All units serviced to full production standards using original factory parts.
CUSTOMER SERVICE
If you need support in installing or using your EXL30 telephone, then please contact the Clarity
Customer Service (see page 1).
UK
12