Grex G4.1 PRO Sicherheit Und Gebrauchsanleitung Seite 17

SIDE PLATES
(Available as standard or accessory/spare part).
When the G4.1 PRO helmet is configured without visor, assembling the side plates in
its place is recommended.
7. Side Plates Assembly
To assemble the side plates, first remove the safety cover, the lateral latches and - if
assembled - the visor (see instructions above).
7.1. Push the left visor mechanism deformable fastening "D" upwards until it is out
of its shell seat and then remove the mechanism from the helmet, paying parti-
cular attention not to lose the visor mechanism springs on its back (Fig. 11).
7.2. Insert the teeth of the left side plate in their side seats on the shell, then push
the plate towards the inside of the helmet near the deformable fastening "E"
(Fig. 12).
NOTE: The left and right side plates are different from each other and are mar-
ked on their back as R (Right) and L (Left).
7.3. Follow the same steps on the right side of the helmet.
8. Side Plates Disassembly
8.1. Push the left side plate deformable fastening "E" upwards until it is out of its
shell seat, then remove the plate from the helmet (Fig. 12).
8.2. Insert the teeth of the left visor mechanism in their side seats on the shell, then
push towards the inside of the helmet near the deformable fastening "D". (Fig. 11).
NOTE: The left and right visor mechanisms are different from each other and are
marked on their back as R (Right) and L (Left).
8.3. Follow the same steps on the right side of the helmet.
8.4. If you wish to assemble the visor, see the assembly instructions above.
8.5. Then assemble the lateral latches and the safety covers on both sides of the
helmet as indicated in the assembly instructions above.
WARNING
- When using the helmet in a configuration without visor, always assemble the
lateral latches and the safety covers supplied. Alternatively, it is recommended
to assemble the side plates.
- Do not use the helmet if the visor, the side plates or the lateral latches and their
safety covers have not been assembled properly.
- Should any of the side mechanisms, latches or any of the safety covers fail or
be damaged, please contact a Grex authorized dealer.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™
nate moulded sunscreen with scratch-resistant/fog-resistant treatment. Very simple
and practical to use. Just lower to activate it or lift to remove it from the field of vision.
It is useful in all sorts of situations, both on long journeys out of town and shorter
town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
(*) LEXAN is a trademark of SABIC.
17
(*) polycarbo-