Controls And Functions - Synq SMX1 Bedienungsanleitung

USER MANUAL

CONTROLS AND FUNCTIONS

CONTROLS ON THE BACK:
1. MAINS INPUT: Use the supplied mains cable to connect this input to the mains.
2. MASTER1 BALANCED OUTPUT: The XLR-connectors can be used to connect
the SMX-1 to the PA, using special balanced signal cables.
3. TRIM OUTPUT: This potentiometer is used to reduce the output level of the mixer
to protect the connected amplifiers and speaker cabinets. (Attention: the output
level can be reduced to zero. If you don't have any signal on the master output,
first check if this potentiometer is accidentally put to zero.)
4. DIGITAL OUTPUT: This digital output makes it possible to make digital recordings
on any connected digital recorder. The output is not affected by the master fader.
5. FADER CONTROL: When connected to these inputs, compatible CD-players can
be controlled by the fader starts and cross fader effects of the SMX-1.
6. MASTER1 UNBALANCED OUTPUT: The same output signal as on the balanced
master output(2) but unbalanced. Can be used to connect unbalanced amplifiers.
7. ZONE OUTPUT: Also called master2 with separate level control, used to connect
extra amplifiers.
8. RECORD OUTPUT: Carries the same signal as the master outputs but is not
influenced by the master level, balance and mono/stereo controls. Used to connect
analog recording equipment.
9. LINE INPUT: Used to connect any line level unit you have (CD, tuner, MD, ...)
10. PHONO/AUX INPUT: Normally used to connect a turntable but, when you put the
"phono/aux" switch(11) in the right position, you can also connect any line level
unit.
11. PHONE/AUX SWITCH: Used to choose the input level of the "phono/aux
input"(10).
12. GROUND (GND) CONNECTION: Many Turntables have a GND-connection. It is
preferable to connect this signal ground to the GND-connector.
13. MIC 2&3 INPUTS: Used to connect 2 extra unbalanced microphones.
SYNQ 3/63
ENGLISH
SMX-1 DJ-MIxer