ULAIZER HOME CN-02 MY Benutzerhandbuch Seite 29

USER'S MANUAL
Guidance and manufacturer's declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environment specified below. The customer or the
user of the device should assure that it is used in such an environment.
Immunity test EN 60601 test level
Electrostatic ±6 KV contact
discharge (ESD) ±8 KV air
IEC 61000-4-2
Electrical fast t ±2 KV for power supply
transient/burst lines
IEC 61000-4-4
Surge IEC 61000- ±1 KV line(s) and neutral
4-5
Voltage dips, 5 % UT
short (>95 % dip in UT)
interruptions for 0.5 cycle
and voltage 40 % UT
variations on (60 % dip in UT)
power supply for 5 cycles
input lines 70 % UT
IEC 61000-4-11 (30 % dip in UT)
for 25 cycles
>5 % UT
(>95 % dip in UT)
for 5s
Power frequency 3 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
Note: UT is the a.c. mains voltage prior to application of the test level.
Compliance level
±6 KV contact
±8 KV air
±2 KV for power supply
lines
±1 KV line(s) and neutral Mains power quality should
<5 % UT
(>95 % dip in UT)
for 0.5 cycle
40 % UT
(60 % dip in UT)
for 5 cycles
70 % UT
(30 % dip in UT)
for 25 cycles
>5 % UT
(>95 % dip in UT)
for 5s
3 A/m
29 EN
Electromagnetic environ-
ment - guidance
Floors should be wood,
concrete or tile. If floors are
covered with synthetic ma-
terial, the relative humidity
should be at least 30%.
Mains power quality should
be that of a typical com-
mercial or hospital envi-
ronment.
be that of a typical com-
mercial or hospital envi-
ronment.
Mains power quality should
be that of a typical com-
mercial or hospital envi-
ronment. If the user of the
device requires continued
operation during power
mains interruptions, it is
recommended that the de-
vice be powered from an
uninterruptible power sup-
ply or a battery.
Mains power quality should
be that of a typical commer-
cial or hospital
environment.