Usage - ULAIZER HOME CN-02 MY Benutzerhandbuch

EN 22
1. Remove your ULAIZER HOME CN-02MY unit from the packaging, place it on a flat
and stable surface. Be sure that you can easily reach the controls when you are
seated and ensure that the ventilation slits are free.
2. Make sure the switch in the "OFF" position.
3. Gently twist the top part of the nebulizer bottle counter-clockwise to disassem-
ble the nebulizer bottle (Figure 1).
4. Fill the nebulizer bottle with the medication prescribed by your physician (Fig-
ure 2).
Note: Fill with medication directly into the nebulizer bottle, do not fulfill. The
recommended fill level is 5ml.
Use medication only on the advice of a physician, and check the appropriate inha-
lation duration and quantity for your needs.
5. Gently twist the top part clockwise to re-assemble the nebulizer bottle. Be sure
the two sections fit well (Figure 3).
6. Connect the air tube with nebulizer bottle (Figure 4).
7. Connect the other end of the air tube to the tube connector on the nebulizer
unit by lightly turning it (Figure 5).
8. Firmly connect the mask, mouth piece, nose piece with nebulizer bottle (Figure 6).
9. Hold the nebulizer bottle as shown on the picture and follow the instructions of
your doctor or respiratory therapist. Exhale as normal through the mouth piece,
mask or nose (Figure 7, 7a).
10. Plug the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at "OFF" position.
11. Press power switch to begin your prescribed treatment.
12. Switch off the nebulizer device after treatment. Unplug the power cable from
the electrical outlet.
Fig. 1

4. USAGE

Fig. 2 Fig. 3 Fig. 4