Limit Switch Adjustment - GBD GECO LUX series Montageanleitung

PROFESSIONAL AUTOMATIC SYSTEM FOR GATES AND GARAGE DOORS
Options:
• Connector to plug in radio control, only for AS02190.
• Semaphore card.
• Buf fer batter y.
Functions:
• Deceleration during opening (1 sec) and closing (4 sec).
• Selectable automatic reclosing with pause time adjustable between 8-90 sec.
• Selectable pre-flashing function during closing.
• Electronic control of thrust force.
Operator assembly:
Photo 02 Equipment required for installation.
Photo 03 • Join the steel profiles to the coupling, ensuring that the coupling is about halfway.
Photo 04 • Fit the steel profile into place in the motor body untillstop is reached.
• Wind the chain around the pinion.
Photo 05 • Mount the bracket using the screws and washers.
Photo 06 • Mount the chain transmission block, fitting the washer, spring, washer and nut.
• Slightly tighten the chain.
Photo 07 • Mount the bracket...
• ... using the screws, washers and nuts.
Photo 08 • Fit the bracket in the centre of the door frame or to the wall using the screw anchors provided in the accessor y pack.
The minimum distance from the maximum sliding point of the door is 30 mm.
Photo 09 • Bend the brackets to size on the upper par t
Photo 10 • Mount the brackets, using the screws and washers.
• Mark the position of the fixing bracket holes.
• Drill the holes and fix the unit to the ceiling with the screw anchors provided in the accessory pack..
Photo 11 • Fit the draw bracket to the centre of the door using the screws provided in the accessor y pack.
Photo 12 • Connect the arm to the draw bracket, taking care not to lock the arm.
Caution: Arrange the power cable in such a way that it does not come into contact with the moving parts (pinion – chain) as th
insulation could be damaged.

Limit switch adjustment:

Important: The limit switch intervention does not lock the movement, but determines the start of the deceleration phase of the
movement.
Photo 13 • Release the plate of the limit switch block by undoing the screw
• Pull the plate sideways freeing the ring nuts of the limit switches.
Photo 14 • Act on the upper ring nut to adjust the opening limit switch point.
Photo 15 • Act on the lower ring nut to adjust the closing limit switch point.
• When the adjustment has been made, refit the ring nut locking plate tightening the screw.
Photo 16 • To obtain better adjustment of the closing manoeuvre it might be necessar y to act on the drive rod of the door.
Fig. 17 Drive Unit Equipment - See Drawing 17 for connections
Trimmer adjustment
Photo 18 Pause time (RV1):
• Completely turned anticlockwise, automatic closing is disabled (step-by-step operating mode).
Increasing the time, automatic closing is enabled from 8 sec. up to a maximum of about 90 sec.
• It is recommended to disable automatic closing during the installation tests.
• The factor y setting is zero. All turned anticlockwise.
When the card is powered, the courtesy light will flash to indicate that automatic closing is active.
9
English
e
door