Ultrabasic Meter Quick Reference - Denver Instrument Ultrabasic Handbuch

UltraBasic Meter Quick Reference

1. Install a 9-volt battery in the battery
compartment or connect an AC
adapter to the power connection
(optional).
2. Connect an electrode to the Input
and ATC connectors (optional).
3. Press mode until the desired
measurement mode (pH or mV/
relative mV) is displayed.
4. Standardize the meter using up
to three buffers by immersing the
electrode in a buffer, stirring, then
pressing standardize to enter each
buffer.
5. The display shows the current
reading in pH, mV, or relative
mV units.
6. Press setup to review electrode
calibration and to clear or select
buffer sets.
UP-10
S
4 7 10
setup
mode
standardize
pH/mV Meter
°C
pH
enter
7