Operation; Automatic Switch-Off - Hama Selina Bedienungsanleitung

g Operating Instructions
BATTERY
TO REPLACE BATTERY
Contact
Black tab
Picture 1
Battery baffle
Picture 2

OPERATION

AUTOMATIC SWITCH OFF
8
Type 1.
1x3V lithium battery (CR2032).
Please remove the isolation sheet from the battery contact before use.
Condition 1:
Open battery case cover on the back of scale, if battery case is the type shown in picture 1,
A. Bend the small black tab outwards and the battery will come out. Take note not to bend the contact.
B. Install new battery by putting one side of the battery beneath the contact and then pressing
down the other side.
Condition 2:
Open battery case cover on the back of scale, if battery case is the type shown in picture 2,
A. Take out the used battery with the aid of a sharp object, as shown in picture 2.
B. Install new battery by putting one side of the battery beneath the battery baffle and then pressing
down the other side.
STEP 1.
Put the scale on a hard & flat surface (avoid carpet or soft surface).
STEP 2.
Gently step on the scale, then the scale will be automatically turned on. Stand evenly until on
the scale without moving and wait until your weight shown on display is stable and locked.
When you step off the scale, it will automatically switch off. Auto shut-off occurs if display
shows "0.0" or show the same weight reading for approximate 8 seconds.