Technical Parameters - Sthor 78121 Bedienungsanleitung

PROPERTIES OF THE TOOL
The jigsaw is an electric tool designed for cutting of wooden surfaces and surfaces made of wood and those made of wood
derivatives, polyethylene and soft metals, using adequate blades. The tool permits easy cutting of the processed surfaces, with a
possibility of adjusting the angle. A correct, reliable and safe operation of the tool depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual. Using the tool for purposes it has not been designed for will make the guarantee void.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. except for the installation of the blade, which is described
further in this manual. The product is supplied with the battery charger and charging station (charger).
Attention! The product of the catalog number: 78122 has not been equipped with a rechargeable battery and charging station.

TECHNICAL PARAMETERS

Parameter
Catalog number
Rated voltage
Rotations
Insulation class
Cutting thickness max.
- wood
- polyethylene / polypropylene
- soft metals
Weight
Noise level:
- accustic pressure L ± K
pA pA
- accustic power L ± K
wA wA
Vibration level a ± K (cutting of wood / metal)
h
Degree of protection
Type of the battery
Capacity of the battery*
Charger*
Input voltage
Mains frequency
Rated current
Output voltage
Input current
Time of charging**
* only for models equipped with battery and charger
* * charging time applies only to the battery with a capacity listed in table
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents. Do not
work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours. Elec-
tric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours. Do not allow children
and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
O R I G I N A L
12
GB
Unit
[V]
[min ]
-1
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
[Ah]
[V~]
[Hz]
[A]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
78121, 78122
12 DC
2100
III
50
10
5
0,8
88,2 ± 3,0
99,2 ± 3,0
4,300 ± 1,5 / 5,154 ± 1,5
IPX0
Li-Ion
1,5
100 - 240
50 / 60
1,0
13,5 DC
1,8
1