Electrolux EVD14900 Bedienungsanleitung Seite 14

14 www.electrolux.com
The vacuum
cycle starts,
activiating the
vacuum pump,
but then stops
within a few
seconds and
the button will
flash
evacuating the
tank or sealing
the bag).
Alarm messages
Alarm
The
flash continuously.
The
flash continuously.
The
buttons flash
continuously.
The
flashes
continuously.
Only the
button flashes
continuously.
www.markabolt.hu
The cover has not been closed.
The cover gasket is dirty or
worn.
(without
Possible cause
button will The electrical board
is faulty.
The vacuum is not produced.
button will
The pump oil
and
must be replaced.
The packaging cycle is
button
terminated in advance
because a wet product is
being packaged.
The machine is in "first start-
up" mode (see the installation
instructions – phase 13).
Apply light pressure to the top
of the cover to create an airtight
seal.
Clean the gasket.
Replace the gasket.
Solution
Contact the Technical
Assistance Service.
Clean or replace the cover
gasket.
(contact the Technical
Assistance Service to replace it).
Make sure the cover closes
correctly.
Press the button to reset the
alarm.
Contact the Technical
Assistance Service.
Press the button to reset the
alarm.
Close the cover with light
pressure and press the
button. All of the buttons light up
and the oil reconditioning cycle
starts ( , flash).
Wait 15' for the procedure to
finish.