Troubleshooting - Electrolux EVD14900 Bedienungsanleitung

8. TROUBLESHOOTING

CAUTION!
Refer to the chapters on safety.
8.1 What to do if...
Problem
The pouch is not
sealed correctly.
Final vacuum is
poor.
The cover does
not open.
The cover is
cracked or
broken.
The
buttons flash.
The machine
turns off and the
pump activates
automatically
after the cover is
closed.
www.markabolt.hu
Possible cause
The sealing time is not correct.
The cover gasket is dirty or
worn.
The pouch is not placed
correctly on the sealing bar.
The sealing bar is worn (the
Teflon coating is burnt).
The blade placed under the
Teflon of the sealing bar is
broken.
The set vacuum level is not
correct.
The cover gasket is dirty or
worn.
The cover is not closed
correctly.
Impurities contained in the
pump oil.
No power supply.
Damaged cover.
"Reconditioning cycle"
and
in progress.
The oil reconditioning program
has been automatically
activated (see par. 6.6).
ENGLISH
Solution
Change the sealing time.
Clean or replace the cover
gasket (contact the Technical
Assistance Service for a
replacement).
Position the pouch correctly.
Replace the sealing bar (contact
the Technical Assistance
Service for a replacement).
Replace the blade (contact the
Technical Assistance Service for
a replacement).
Change the vacuum level.
Clean or replace the cover
gasket (contact the Technical
Assistance Service for a
replacement).
Close the cover correctly.
Make sure that objects or dirt
are not found between the cover
and tank.
Run an oil "reconditioning cycle"
(see par. 6.6).
Wait until the power supply is
restored.
Replace the cover (contact the
Technical Assistance Service for
a replacement).
Wait for the end of the
"reconditioning cycle" (15 minutes).
Wait for the end of the
"reconditioning cycle" (15
minutes).
13