Cleaning And Maintenance - Electrolux EVD14900 Bedienungsanleitung

12 www.electrolux.com
6.6 Reconditioning cycle
This function is used in the following
situations:
• Before using the appliance for the first
time.
• After extensive downtime.
• After having sealed products with high
humidity content (e.g. soups).
• When you notice a decrease in
appliance performance (e.g. more time
to vacuum or it does not vacuum at all).
This program lasts about 15 minutes and
guarantees the complete cleaning of the
pump, removing any liquid emulsion that
might be found in the oil.
Do not seal any product while this
program is running.

7. CLEANING AND MAINTENANCE

CAUTION!
Refer to the chapters on safety.
• Clean the appliance after each use
with a damp and soft cloth.
www.markabolt.hu
Proceed as follows:
• Hold down the
• Close the cover with light pressure.
• Press the
• At the end of the cycle (15 minutes)
• Clean the Plexiglas cover
• Do not use abrasive products, alcohol-
• Follow the safety instructions indicated
1
• Clean the tank
• Clean the sealing bar
• Clean the metal surfaces using normal
• Keep the control panel clean and dry.
4
6
button until all the
buttons flash.
button. The
buttons flash while the program runs.
the button will stop flashing and the
appliance will be ready for use.
and out using only neutral detergents
(water and soap).
based detergents, abrasive sponges,
solvents or metal objects.
on the packaging when using products
to clean the steel tank
6
, especially in the
case of residue liquid, it is advisable to
remove the sealing bar
Remove any residue that deposits on
the bar.
detergents suitable for stainless steel.
and
1 inside
.
6
upwards.
4
with a dry cloth.
4