Chip Extraction; Maintenance - T.O.M TSR-210 Bedienungsanleitung

7.6 Precision adjustment of the stop for 45° mitre cuts (Fig. 1-2-4-7)
• Lower the machine head (4) and fix with the lock pin (16).
• Fix the rotary table (8) in 0° position.
• Undo the locking nut (13) and, holding the handle (2), tilt the machine head (4) to the left by 45°
• Place the 45° stop angle (b) between the saw blade (5) and the rotary table (8).
• Slacken the counter nut and adjust the setting screw (22) until the angle between the saw (5) and the rotary table (8) equals
exactly 45°.
• Re-tighten the locking nut (13) and make the cut as described in Section 7.2.
7.7 Mitre cuts 0°-45° and rotary table 0°-45° (Fig.1-2-4)
The TSR-210 can be used to make mitre cuts on the left at an angle of 0°-45° relative to the work top and 0°-45° relative to the stop
rail
• Lift the machine head (4) to its top position.
• Release the turntable (8) by loosening the locking grip (10).
• Adjust the rotary table (8) by its handle (2) to the required angle (see also Section 7.4)
• Re-tighten the locking handle (10) to fix the rotary table in position
• Undo the clamping nut (13) and, holding the handle (2), tilt the machine head (4) to the left to the required angle dimension
(see also Section 7.5).
• Re-tighten the locking nut (13) and make the cut as described in Section 7.2.

7.8 Chip extraction

The saw is equipped with a chip collection bag. The chip bag can be emptied by opening the zip fastener at the bottom.
7.9 Replacing the saw blade (Fig. 1-2-6)
• Pull out the power plug.
• Swing up the machine head (4).
• Press the lever and swing up the saw blade guard to the point where the recess in the saw blade guard is above the flange
bolt.
• Press the saw shaft lock (24) with one hand while holding the wrench (31) on the flange bolt with the other.
• Firmly press on the saw shaft lock (24) and slowly rotate the flange bolt in clockwise direction. The saw shaft lock engages
after no more than one rotation.
• Now, using a little more force, slacken the flange bolt in clockwise direction.
• Turn the flange bolt until it is completely removed.
• Take the blade (5) off the inner flange and pull out downwards.
• Mount the new saw blade in reverse order and fasten.
Important! The cutting bevel of the teeth, i.e. the direction of rotation of the saw blade, has to conform with the direction of the
arrow marked on the housing.
• Clean the saw blade flanges thoroughly before mounting the saw blade.
• Reattach the movable blade guard (6) in reverse order.
• Before using the saw again, check that the safety devices are in good working order.
• Important : every time that you change the saw blade, check to see that it spins freely in the groove of the turntable in both
perpendicular and 45° angle settings.
7.1 Laser function (Fig. 8)
• You can switch the laser ON and OFF with the switch (a).
• The laser (35) directs a beam onto the work-piece.
• Extremely precise cuts can be made using the laser function.

MAINTENANCE

• Keep the machine's air vents unclogged and clean at all times.
• Remove dust and dirt regularly from the machine. Cleaning is best done with compressed air or a rag.
• Re-lubricate all moving parts in regular intervals.
• Never use caustic agents to clean plastic parts.
20