Technical Data - T.O.M TSR-210 Bedienungsanleitung

TECHNICAL DATA

Asynchronous motor
Output
Idle speed no
Carbide-tipped saw blade
Number of teeth
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
(double mitre cuts)
Weight
Laser class
Laser wave length
Laser output
Laser module power supply
BEFORE PUTTING THE MACHINE INTO OPERATION
It must be possible for the saw blade to run freely.
When working with wood that has been processed before, watch out for foreign bodies such as nails or screws etc.
Before you connect the machine to the power supply, make sure the data on the rating plate is the same as that for your mains
ASSEMBLY
7.1 Setting up the saw unit (Fig. 1/2)
• To adjust the turntable (8), loosen the locking handle (10) by approx. 2 turns, which frees the turntable (8).
• Turn the turntable (8) and scale pointer (11) to the desired angular setting on the dial (12) and lock into place with the loc-
king handle (10).
• Lightly press the machine head (4) down while at the same time pulling the retaining pin (16) out from the motor mounting;
this causes the saw to move down to the lower working position.
• Swing the machine head (4) up until the retaining hook latches into place.
• The clamping device (19) and the workpiece support (20) can be fastened on both the right and left sides of the base plate
(9).
• By loosening the tightening screw (13), the machine head (4) can be angled to the left up to 45°.
18
230V – 50 Hz
1500 W S6 25%
5000 min
o210xo30x2.8 mm
24
-45°/0°/+45°
0° to 45° to the left
65 x 305 mm
65 x 210 mm
35 x 210 mm
15 Kg
2
650 nm
<< 1mW
2x1.5V Micro (AAA)
.