Troubleshooting - Klarstein 10033283 Handbuch

Non-friendly cookware
Uneven
pot bottom
System protection functions
1 Plate overheating protection: When the hotplate heats up to 650 °C, it is
automatically cooled down.
2 Inner overheating protection: When the inner temperature of the machine reaches
100 °C, heating is stopped.
3 Overvoltage protection: If the voltage exceeds 270 V, the hotplate will not be
heated any further.
4 Low voltage protection: If the voltage is below 100 V, the hotplate will not be
heated any further.
5 Constant power protection: If the power supply voltage increases (in 270 V) and
the output current declines, the maximum output power decreases with changes.

TROUBLESHOOTING

Problem
Plug the mains plug into the wall socket.
Press the ON/OFF button, the display
does not light.
The On/Off indicator does not light.
During operation, the heating process is
suddenly stopped.
The power cord is damaged.
Pot bottom Pot bottom with
with feet small diameter
Possible Solution
Check that the mains plug is plugged
into the wall socket correctly and that
the wall socket is in good condition.
Check if the display or the main board
are in good condition.
Check whether the following causes
have occurred: the surrounding
temperature is high or the set timer time
has been reached. If the overheating
protection has been started, do not put
the hotplate back into operation until
after 10 minutes. The hotplate switches
off automatically during operation after
2 hours of non-use.
Have the defective power cord replaced
by an authorized electrician with a
power cord of the same model.
EN
21