WimTec SanTec PROOF W6 Montage- Und Bedienungsanleitung Seite 25

Assembly
12
15
!
ATTENTION!
Perform the following steps
in the order indicated!
PROOF W6
13
16
12. Correctly align the mounting frame.
Apply the included special grease to the front of the valve.
13.
Connect the mounting frame sensor cable to the electronics
module.
14. Configure the desired functions at the electronics module, and
insert the module into the flush-mount kit.
15. Check the thermostat position – the arrow should be pointing
upwards.
16. Check the position of the thermostat knob – the locking knob
should be pointing directly upwards.
17.
Insert the front plate at an angle, and apply some pressure
while turning it until it is aligned horizontally.
14
17
SanTec OCEAN W6
Wall tap control
EN
25