Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GALESKI MANUFAKTUR
ENGLISH
1. Specified Conditions of Use
The POLIFOX and JOKER machines are
designed for using suitebale diamond tools
for wet polishing on marble, granite, ce-
ramics and artificial stone. They work with
resin-based diamond grinding discs or metal
based diamond abrasive wheels or cups for
squaring (edging) and milling.
The machines are suitable under certain
conditions also for conventional abrasive
tools and methods which need high working
pressure with low (revolution-) speed.
The national (local) working safety rules (e.g.
Law on the Safety of Technical Appliances)
are applicable for its proper use. This
electric power tool developed by us is in
strict conformity with legal requirements
for technical appliances, which are for the
protection of health and life during its use.
Do not use this product in another way as
stated for normal use.
2. Safety Advice
Read operating instructions thoroughly!
Observe safety instructions (see red insert-
sheet !)
• Do not pierce the motor housing, as this
could damage the double insulation (use
adhesives).
• Always pull the plug from the mains (power
supply) before making any settings or
carrying out maintenance.
• Only plug in when machine is switched off.
• Keep mains clear from working range of the
machine. Always lead the cable away behind
you.
• Before use check machine, cable and plug
for any damages or material fatigue. Repairs
should only be carried out by authorised
service agents.
• After switching off, the machine will not be
idle immediately. (After-running of the work
spindle.) Allow the machine to come to a stop
before putting down.
• Never reach into the danger area of the
machine when it is running.
• Never allow children to use the machine.
• Always wear safety goggles and ear
protectors when working with this machine.
It is further recommended to wear safety
Original Instruction POLIFOX 1400/1502 Vario • ENGLISH
gloves, apron, as well as sturdy non-slipping
shoes.
• Only use tools approved for speed of at
least as high as the highest no-load speed of
the machine.
• Pay attention to the dimensions of the tools.
Use only tools with suitebale thread (M14 or
5/8 -11 UNC).
• Check grinding tools before use. The
grinding tool must be properly mounted and
turn freely. Do not use damaged, out-of-round
or vibrating grinding tools.
• Dust that arises when working in stones
with crystalline silicic acid can damage your
health. Do not work o any material containing
asbestos. Please note the safety regulations
of the employer´s liability insurance
association.
• Immediately switch off the machine in
case of considerable vibrations or if other
malfunctions occur. Check the machine in
order to find out the cause.
• The workpiece must be fixed if it is not
heavy enough to be steady. Never lead the
workpiece to the grinding disk with your hand.
• In case of extreme operating conditions
strong contamination can build up inside the
machine. In such cases it is recommended to
shorten the cleaning cycles and regular blow
out with compressed air.
• Be careful of hidden electrical lines or gas
and water pipes. Check the working area, e.g.
with a metal detector.
• Typically the A-weighted noise levels of the
machine are:
Sound pressure level: 89 dB (A)
Sound power level: 102 dB (A)
Wear ear protectors!
• Typically the weighted acceleration is
7 m/s
ing to EN 60745).
3. Before Operation
3.1 Mounting of Tools
Lock the work spindle (3) by depressing the
spindle lock (1). (Refer to picture at chapter
no. 14.)
Attention! Use spindle lock only when working
spindle is not in operation!
Mount tool and tighten with appropriate span-
ner.
7
(Measured values determined accord-
2
Werbung
Inhaltsverzeichnis
