Assembly - LIVARNO LUX LSS 520 A1 Bedienungsanleitung Und Serviceinformationen

LIVARNO LUX LSS 520 A1

Assembly

Solar LED spotlight (1):
 Detach the mounting bracket (3) from the solar LED spotlight (1).
 Utilise the mounting bracket (3) as a template for marking the position of the two outer drill holes.
 Then drill these holes and attach the mounting bracket (3) using the supplied large dowels and
screws.
 Now attach the solar LED spotlight (1) to the mounting bracket (3) using the previously removed
screws, spring washers and flat washers. Please make sure that the spring washers are located
between the solar LED spotlight (1) and the mounting bracket (3). The flat washers must be located
between the screw head and the mounting bracket (3).
Solar panel (7):
A mounting plate with 6 drill holes for screws is located at the back of the solar panel (7).
 Mount the solar panel at the designated
location using the 4 small screws and dowels.
Depending on the topography of the mounting
location, you can freely choose 4 of the drill
holes in the mounting plate; however, you
should ideally select 2 drill holes on the right
and left each. The solar panel (7) is connected
to the mounting plate via a swivel joint. Align
the mounting plate such that you can fasten
the 4 small screws with ease.
 Then lay the cable (8) and connect the plug to
the cable (6) socket of the solar LED spotlight
(1).
 The solar panel (7) is connected to the
mounting plate via a swivel joint. Orient the
solar panel in a manner that ensures maximum
exposure to sunlight.
44 - English