auna AB-650 Handbuch Seite 7

 Connect the AUX input wires with RCA type pin jack as follows: white to L Ch pre—output of the car
stereo. Red to R Ch pre—output of the car stereo.
 Before connecting the pre—output of the car stereo or other unit, confirm the impedance or
sensitivity to match with this unit AUX input.
 Adjust the input sensitivity to output of a car stereo connected.
 Connect the speaker wires as per the figure1.2.
Note:
 Because og high power unit, approx 7,5A/ 15A/ 20A will be drained at peak power. Using the unit
while the engine is stopped may totally discharge the battery. Please run the engine in using the
unit.
 Because of large current flows, please use power supply cord of sufficient capacity if required.
(Larger than 3mm square.)
 This unit is designed of use with the speakers 2~16Ω impedance. The speaker must have enough
capacity to accept the high power of the unit. Please carefully confirm the rating of the speaker
before connection.
4. Connection of AUX Input (Low Input)
5. Input Sensitivity Control
6. Connection of Speaker (Stereo / Mono)