Hama DR-50 Handbuch Seite 9

L DR-50 ADSL modem router instructions
Connecting the Wireless ADSL Router:
- The unit may not be operated in the vicinity of heaters or in dusty or moist areas.
- Unplug the unit from the power supply before connection.
- Connect the computers, other network devices, hubs/switches to sockets 1-4. Use a crossover
or CAT5 patch cable (max. 100m). The integrated switch automatically identifies the connection
speed of 10 or 100Mbps, half/full duplex transfer mode and the type of cable used.
- Connect your splitter to the "WAN" connection on the router.
- Plug the power unit supplied into an empty socket and connect it to the router. Caution:
Unsuitable power units can cause damage!
- Switch on the modem router by pushing the lever at the rear up.
- If you are using a computer or notebook without a network card, but with a USB port, you
can also connect it to the modem router via the USB port.
Checking the installation
There are 12 LEDS on the front to display the status:
LED Condition
POWER Lit
Off
Ready Flashing
Off
Show Time Lit
Off
RxD Lit
Off
LAN 1- 4 Lit
Flashing
Off
Status
Power unit is connected and supplying electricity
No power unit connected, device not being supplied with electricity
The modem router has been started and is ready for operation
Firmware error or initialisation error
A proper ADSL session has been established
No connection to splitter or invalid ADSL session
Indicates an active WAN session
Currently no active WAN session
The corresponding LAN port has generated a correct network
connection
Data transfer via respective LAN port
No connection