User's Instruction - INFOSEC UPS SYSTEM PFS 7 TGE Gebrauchsanweisung

The PFS 7 TGE was designed to give the highest degree of protection against overloads, voltage peaks,
electromagnetic interference (EMI) and radio frequency interference (RFI).
It protects your computers, peripherals and hi-fi equipment against damage caused by voltage peaks,
lightning, network parasites and overloads. It also protects your phone/fax/modem equipment.
A reset circuit breaker protects against overloads and blowouts.
Security
Please read all these instructions before installing the PFS 7 TGE. It must be installed only inside a protected
location in which the temperature and humidity do not exceed the limits defined in the technical characteristics
section.
Installation
Plug the PFS 7 TGE into a two-pole connector with earth (2P+E-10 A). Plug your equipment to be protected
into the 7 protected outlets on the PFS 7 TGE.
Put the mains switch into the "ON" position and check that the "Protected" and "Power OK" lights are on. If it
does not light on, check the electrical power supply.
If the orange "Protected" light is off, do not use the PFS 7 TGE.
1. Mains switch
The mains two-pole switch of the PFS 7 TGE is used to switch the 7 outlets on and off.
2. Overload protection
When the consumption of connected equipment exceeds the authorized value, the circuit breaker opens to
protect the PFS 7 TGE. To put it back into service, reduce the power and reset the circuit breaker.
3. "Power OK"
Green led "Power OK" turns on: power is effective.
Green led "Power OK" is off: power is not effective.
4. Active surge protection led
Orange led "Protected" turns on: the protection is effective.
Orange led "Protected" is off: the protection is not effective.
5. Protected outlets
Protected outlets are used to connect equipment such as a PC, printer, monitor, scanner, modem, external
CD Rom drive, home DVD player... They are controlled by the mains switch.
6. Transformer power outlets
The 2 space-wide protected outlets are used to easily connect one transformer block.
7. Fax and Modem protection
The PFS 7 TGE is equipped with protection against overvoltages on the telephone / fax / modem line (thanks
to its 2 RJ11 (6P4C) connectors). Connect the line input to the ''IN'' connector and use the cable supplied to
connect the ''OUT'' connector to the telephone / fax / modem.
If there is a problem, do not disassemble the PFS 7 TGE, there are no reparable parts inside it.
Infosec UPS System - 4, rue de la Rigotière 44700 ORVAULT - France - www.infosec.fr
HotLine : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 06 05 08 206 11

User's instruction

Call the After Sales Service.
3