Back Side Panel Area; Charging The Battery; Bout The Ard Isk - SmartDisk PhotoBank Benutzerhandbuch

Back Side Panel Area

The back side panel area contains the memory card slot for your Compact
Flash (CF) and Microdrive (MD) memory cards.

Charging the Battery

PhotoBank uses a built-in lithium ion rechargeable battery to provide
power to the product when used remotely. When the battery is depleted it
will normally take up to 3 hours to recharge fully. Your new battery may
be only partially charged, so before using the unit with battery power you
must first charge the battery. Note that regardless of the state of the
battery, you can always operate the unit while the AC adapter is attached.
To charge the battery, plug the included AC adapter into a wall outlet,
and then plug the adapter's DC plug into the DC input jack on the unit.
When the power adapter is connected, the battery charge LED will be red
while charging and will be green when fully charged.
About the Hard Disk
The PhotoBank internal hard drive comes pre-formatted from the factory
in FAT32 format.
4