salvus PS300 Bedienungsanleitung Seite 61

2.3 Changing the user code (by a user, without the master code.)
Please note – the user code may not be the same as the master code!
Make sure that the safe door is open when you change the code (ON – user code – ENTER).
Up to 9 users can be programmed. They receive an user ID. For exemple, user 1 receives user ID "1".
Step
Press ON
1.
Press Enter
2.
Press 3
3.
Press Enter
4.
Key in a user ID (choose between 1-9), e.g. 1
5.
Press Enter
6.
Key in the current user code, e.g. 111111
7.
Press Enter
8.
Key in the new user code, e.g. 222222
9.
Press Enter
10.
Repeat the new code, e.g. 222222
11.
Press Enter
12.
The new user code is now set. If the new code is not accepted, you hear a long signal and a red light flashes.
In that case, start again at step 1 for changing the user code. After changing the code, it is best to test the new
code several times with the door open.
Action Key
ON
Enter
3
Enter
1
Enter
111111
Enter
222222
Enter
222222
Enter
Signal
61