salvus PS300 Bedienungsanleitung Seite 60

2.2 Setting the user code
You can only set a user code after changing the master code from the factory code to your personalized one.
Please note – the user code may not be the same as the master code!
Make sure that the safe door is open when you change the code (ON – master code – ENTER).
Up to 9 users can be programmed. They receive an user ID. For exemple, user 1 receives user ID "1".
Step
Press ON
1.
Press Enter
2.
Press 2
3.
Press Enter
4.
Key in a user ID (choose between 1-9), e.g. 1
5.
Press Enter
6.
Key in the master code, e.g. 567891
7.
Press Enter
8.
Key in the new user code, e.g. 111111
9.
Press Enter
10.
Repeat the new user code, e.g. 111111
11.
Press Enter
12.
The new user code is now set. If the new code is not accepted, you hear a long signal and a red light flashes. In
that case, start again at step 1 for setting the user code. After setting the code, it is best to test the new code
several times with the door open.
60
Action Key
ON
Enter
2
Enter
1
Enter
567891
Enter
111111
Enter
111111
Enter
Signal