Safety-Related Information On Taking Out Of Operation And Removal; Liability And Exclusion Of Liability - Elektror HRD serie Betriebs- Und Montageanleitung

Operating and assembly instructions HRD FU-ATEX
6 SAFETY RELATED INFORMATION
ON TAKING OUT OF OPERATION AND
REMOVAL
EN
The disconnection of all electrical connections and any
other electrical work in connection with decommissioning
must only be carried out by a qualifi ed electrician.
The device should be dismantled only when all rotating
parts have come to a standstill and cannot be restarted.
The guidelines set out in 2.1 Transport and Handling must
be observed when dismantling and removing it.
Treat the device as industrial waste when disposing of it.
The device parts are made of recyclable material, such as
aluminium, (stainless) steel, copper and plastic. However,
there are components that need special treatment (e.g.
frequency converters). The statutory national and local dis-
posal and recycling regulations must be observed.
7 LIABILITY AND EXCLUSION OF LI-
ABILITY
The owner bears responsibility for the designated use of the
unit.
Elektror shall not be liable in any case of damage resulting
from non-designated use of its units and components.
This also applies, in particular, to special usages and
application conditions, which have not been expressly co-
ordinated with Elektror.
Furthermore, Elektror shall not be liable for damage result-
ing from modifi cations or conversions to the delivered
equipment or accessories, in particular, if such changes can
impair the explosion protection.
Similarly, Elektror shall assume no liability for maintenance
work and repairs, and the possible consequences thereof,
that have been performed incorrectly, with delay, by techni-
cians not qualifi ed by Elektror, or which have not been
carried out at all.
22
www.elektror.com