Troubleshooting - Chal-Tec 10005394 Anschluss- Und Anwendungshinweise

NOTE :
a). Keep a distance of the speaker up to 7 meters apart from the transmitter, and then press the
button for the best reception.
b) Whenever you find frequency jam, move your channel switch from one channel to the other
channel (there are two channels for selection) on the transmitter, and then press the
again.
6. You should now be able to place the speakers freely from room to room without disruption.
Should there is any disruption (signal cuts off or carries distortion), press the speaker's
button to maximize the best reception.
If you hear interference from other components, switch on the channel control of transmitter, and
then move the speakers to other free location. You can re-adjust the tuning control by moving it
either channel 1 or 2 of the transmitter, then pressing the
When transmitting / receiving over long distances, the signal from the system will become
weaker.
7. Switching Off
a) For protection of the transmitter and power saving, the transmitter will cut off automatically
if there is no/weak operation input signal from audio source for 4 minutes.
In other words, if the signal comes back, the transmitter will work again automatically.
b) Press the
NO SOUND
Ensure the AC/DC adaptor is fully inserted into the AC outlet and the power connection
-
input on the transmitter.
Ensure the speaker is switch ON.
-
Speaker's battery capacity is too low, replace with new batteries or connect the AC/DC
-
adaptors to the speakers.
Ensure the TV or audio component is ON.
-
The connected audio / video equipment is not playing. Start playing the equipment.
-
The volume of speaker is too low, adjust the volume to an appropriate level.
-
DISTORTED
Press the
-
Change the position of the channel selector on the transmitter. You must then press the
-
button on the speakers.
Battery capacity is too low. Replace with the new battery.
-
Ensure the volume level of speakers is adjusted properly.
-
The speaker is too far away from the transmitter, move it closer.
-
The input level of the audio signal is too low. Turn up the volume of the audio source
-
equipment.
button to turn off the speaker and the LED light goes off.
TROUBLE SHOOTING
button on the speakers until matching the frequency of the transmitter.
button for best reception.
button