Inhaltsverzeichnis
Werbung
2.6. Adjusting the Water
Hardness
Your appliance can be adjusted to the
hardness of the water used. The water
hardness must be adjusted correctly so
that the automatic calcification indi-
cator can function correctly (see also
Section 9).
Note: The water hardness setting need
only be adjusted prior to using the
appliance for the first time, or if the
quality of the water used changes.
Use the Aquadur® test strips supplied
to determine the hardness of the local
water and follow the instructions given
on the test strip packaging. Or ask your
water board about the hardness of
your water!
The appliance has
4
hardness settings.
The factory setting is the middle set-
ting, 3 (corresponding to 16°-23°
degrees German hardness).
You can change this setting as follows:
0 Set the programme selector (Figure 1/Q)
to Position 7. "HARDNESS LEVEL 3"
appears in the display.
0 Keep pressing the selection button on
the programme selector until the
required water hardness (1-4) or else
"OFF" or "FILTER" appears in the display.
If the water hardness is 2, "HARDNESS
LEVEL 2" appears in the display.
0 Return the programme selector to
Position 1 to store the displayed value.
The appliance is now ready for brewing
coffee.
If "LEVEL-" appears in the display, the
water hardness has not been set. The
decalcification warning will never
appear. This setting may only be used if
you have an independent water sof-
tening system.
If you are using a water filter, select
the "FILTER" setting. The appliance will
then automatically detect when the
filter needs to be changed.
Please also refer to Section 2.7 below,
Inserting the Water Filter.
2.7. Inserting the Water Filter
The appliance is fitted with a water fil-
ter. This water filter helps to remove
the majority of such elements as chlo-
rine from tap water that might other-
wise spoil the flavour. In addition, the
lime content in the water is greatly
reduced when the water filter is used.
This allows the full flavour of your cof-
fee to develop.
If a water filter is used in the appli-
ance, we recommend decalcifying the
appliance once or twice a year.
Inserting and Changing the Water
Filter (Figure 4)
0 Remove the water filter that comes
with the appliance from its plastic
packaging and rinse it thoroughly
under running water.
0 Raise the lid at the top of the water
tank (Figure 1/B).
0 Insert the water filter into the holder
at the bottom of the water tank and
turn it clockwise (Figure 4). Ensure that
the filter is fully and correctly in place!
The filter must be fully screwed in or
else its effectiveness will be reduced.
0 Fill the water tank with tap water and
insert (Figure 5).
0 Rinse the filter cartridge with at least
half a tank of water. To do this, pro-
ceed as described in Section 5, Prepar-
ing Hot Water.
The water might become slightly dis-
coloured (not damaging to health).
The tap water is filtered as soon as it is
drawn in by the pump.
3
The device has automatic filter moni-
toring. When "REPLACE FILTER" appears
in the display, the filter in the water
tank must be replaced.
After the new filter has been fitted, set
the programme selector to Position 7,
Water hardness.
0 Press the programme selector selec-
tion button for approximately
2 seconds. The "REPLACE FILTER"
display will be cleared.
g
25
Werbung
Inhaltsverzeichnis
