Rotating Parts; Hot Surfaces; Installation - Aqua Technix AQUA Maxi series Original-Gebrauchsanweisung

Rotating parts

Risk of crushing or shearing from exposed rotating parts.
- Do not perform any work on the pump unless the power is shut down.
- Before starting work, make sure the pump cannot inadvertently be switched on again.
- Directly after fi nishing work, refi t/reactivate all protective devices.
Electricity
When working on the electrical unit, there is an increased risk of electrocution due to the damp
surroundings.
Incorrectly installed protective conductors can also lead to electrocution e.g. as a result of oxidation or
cable breakage.
• Make sure that the swimming pool and its surrounding protective zone are installed, commissioned and
operated in accordance with the relevant local regulations.
• Before working on the electrical system, take the following precautions:
- Disconnect the system from the electrical power supply.
- Attach a warning sign: „Do not switch on! Work in progress on the system."
- Check for the absence of voltage.
• Regularly check that the electrical system is in proper working order.

Hot surfaces

Risk of burns - the electric motor can reach temperatures of up to 70 °C.
- Do not touch the motor while it is running.
- Let the motor cool down before working on the pump.
Caution
3. General
Please take the necessary precautions when transporting the pump. Avoid intermediate storage in a
damp location or locations subject to signifi cant temperature fl uctuations. Our pumps with built-in fi lter
elements have been designed for pre-fi ltering and for the circulation of swimming pool water. Most plastic
components that come into contact with the pumping medium are made of reinforced polypropylene (PP)
and thus are highly resistant to corrosion by pool water. The water temperature must not exceed 60°C.
Non-compliance with our installation and operating instructions will void any warranty.

4. Installation

Caution
The installation site of the pump must be dry and well
ventilated.
SWhen installed in a closed room, a drainage connected
to the sewers must be installed. The size of the fl oor drain
depends mainly on the size of the swimming pool and the
circulation fl ow rate but also on possible leaks within the pool
water circulation system.
The ambient temperature must not exceed 40°C.
VD21.45.509-P
11