Cabrinha COAX Installationsanleitung Seite 6

4. Open footstrap cover and extend footstrap to its largest size.
5. Place footplate onto the board in the desired stance position. Line up the
inserts with the elongated holes in the plate.
6. Mount the wide side of the footstrap first. Align the screw with the insert
and tighten slightly.
7. Mount the remaining side of the footstrap.
8. Fully tighten mounting screws with a hand held screwdriver.
9. Insert your foot into the footstrap and adjust to size. Close footstrap
cover.
TO GIVE YOUR BOARD / ACCESSORIES A LONG LIFE:
CO-AX Care and Maintenance.
• Always wash the board components after use with fresh water and dry
thoroughly before storing.
• The binding and fin mounting screws are subject to extreme loads
and forces. They should be checked regularly if still tight and if not,
tightened accordingly.
• Ensure that the CO-AX strap is correctly adjusted. Riding with an ill fitted
strap could cause injury to the rider or damage to the strap itself.