Cabrinha COAX Installationsanleitung Seite 5

CO-AX MOUNTING INSTRUCTIONS
INVENTORY LIST
2 – Co-Ax Footstraps
2 – Co-Ax Foot Pads
4 – M6 x 19 mm Footstrap Mount-
ing Screws
4 – Washers
Tools needed:
P3 Screwdriver – Footstraps & Handle
NOTE: This Cabrinha Accessory
is designed for use with Cabrinha
Boards. Use of this accessory with
products of other manufacturers may
result in over-tightening of the screws
and is therefore excluded from any
warranty cover.
NOTE: Do not use powertools to
assemble your board. You will run
the risk of cross threading the inserts.
Doing so will void your warranty.
BOARD ASSEMBLY
1. Identify the right and the left
footplates by the location of the
embossed C logo. The C logos
should be positioned on the side
closest to the center of the board
when installed properly.
2. Identify the right and the left foot-
straps by the location of the C logo.
The C logo should be positioned on
the side closest to the tips of the
board when installed properly.
3. Thread the supplied (M6 x 19 mm)
screws through the washers and
into the holes in the foot strap.