Berner Rotating Laser Multi HV-R Bedienungsanleitung Seite 7

Rotationsmodus
Press the button 2 and the laser Multi HV-R will change into the rotation mode.
Head speed: To change the speed of the rotating beam, press the button 2. Speeds of
0rpm, 60rpm 300rpm & 600rpm (max.) can be obtained.
!
When Working with receiver the highest rotary speed is advisable.
Directional scanning
Press the Speed key 3 until it is at 0 r.p.m, the laser module will stop spinning. Press
the Key Directional scanning; the laser module will scan directionally. If pressing the key
repeatedly, the angle of scanning of laser module will continuously change as follows:
0°-10-°45º-90-°180°-0°.
Press the Key 5 Left-spinning or the Key 4 Right-spinning to change the direction of
scanning.
!
Slope Adjustment
Using the arrow keys, the laser line can be inclined manually. To enter the Manual mode,
press the Manual button 6. In Manual mode a LED next to the button lights. The laser line
can be inclined in two axes. To turn off the manual mode, press the Manual button 6, the
LED next to button 6 switch off.
When pressing the buttons, the device can be out of
level because of the high accuracy of the leveling,
the rotor starts only after the re-leveling of the unit.
When pressing the buttons, the device can be out of
level because of the high accuracy of the leveling,
the rotor starts only after the re-leveling of the unit.
7